Method of directly connecting door jambs

常規注意事項：

General precautions:

材料厚度必須保證1.2厚（實際厚度不得小于1.08）。

The material thickness must ensure a thickness of 1.2 (the actual thickness should not be less than 1.08).

必須注意用豎料來收口門頭橫料。

It is necessary to pay attention to using vertical materials to close the horizontal material of the door head.

注意制作基層一定要小于門套包邊尺寸5mm左右，保證足夠的空間安裝和打膠。

Be sure to make the base layer smaller than the door pocket edge size by about 5mm to ensure sufficient space for installation and gluing.

門口板寬度要略小于豎料寬度1—2mm，收口才美觀。

The width of the entrance board should be slightly smaller than the width of the vertical material by 1-2mm for a beautiful closure.

一般門頭板和立面包板對接處的陰角處不建議用膠水收口，這樣既美觀又能檢測門套安裝質量。

It is not recommended to use glue to close the internal corners of the joint between the door header and the facade panel, as this not only looks beautiful but also checks the installation quality of the door cover.

二普通45°拼接門套做法

Method of making two ordinary 45 ° splicing door jambs

常規注意事項：

General precautions:

材料厚度建議1.2厚（實際厚度不得小于1.08）。注意對角處不能有錯位，焊點處一定要處理在隱蔽位置。

The recommended material thickness is 1.2 (the actual thickness should not be less than 1.08). Note that there should be no misalignment at the corners, and the welding points must be handled in a concealed position.

注意制作基層一定要小于門套包邊尺寸5mm左右，保證足夠的空間安裝和打膠。

Be sure to make the base layer smaller than the door pocket edge size by about 5mm to ensure sufficient space for installation and gluing.

一般門頭板和立面包板對接處的陰角處不建議用膠水收口，這樣既美觀又能檢驗門套質量。

It is not recommended to use glue to close the internal corners of the joint between the door header and the facade panel, as this not only looks beautiful but also checks the quality of the door cover.

本文由菏澤拉絲不銹鋼電梯門套線友情奉獻.更多有關的知識請點擊:http://m.hmqczz.com真誠的態度.為您提供為全面的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.

This article is dedicated by Heze Brushed Stainless Steel Elevator Door Cover Line. For more information, please click on: http://m.hmqczz.com Sincere attitude. We will provide you with comprehensive services. We will gradually contribute more relevant knowledge to everyone. Stay tuned